Sample interview questions: Can you explain the process of pipefitting for water supply and drainage systems?
Sample answer:
- Material Selection:
- Understand the specific requirements of the project, including pressure rating, temperature range, and the intended use of the pipe system (water supply, drainage, etc.).
- Select appropriate piping materials based on the application, such as copper, PVC, CPVC, galvanized steel, or PEX.
-
Consider factors like corrosion resistance, durability, cost, and ease of installation.
-
Pipe Cutting and Preparation:
- Use a pipe cutter or saw to cut pipes to the desired lengths. Ensure clean and square cuts.
- Remove burrs and sharp edges from cut pipe ends using a file or reamer.
-
Apply a thin layer of pipe dope or sealant to the male pipe threads to ensure a leak-proof connection.
-
Pipe Bending:
-
If necessary, bend pipes to create bends or offsets. Use a pipe bender or bending springs to achieve the desired angle or shape without kinking or collapsing the pipe.
-
Assembling Pipe Joints:
- Apply a thin layer of sealant or pipe dope to the female pipe threads.
- Hand-tighten the pipe fitting onto the pipe until it is snug.
-
Use a wrench or pipe wrench to tighten the fitting further, ensuring a secure connection. Avoid overtightening to prevent damage to the threads.
-
Installing Valves and Fixtures:
- Determine the location of valves, faucets, and other fixtures based on the design requirements.
- Install valves and fixtures using appropriate fittings, ensuring proper alignment and orientation.
-
Use sealant or Teflon tape to ensure a leak-proof seal between the valve or fixture and the pipe.
-
Pressure Testing:
- Once the piping system is assembled, conduct a pressure test to check for leaks. Close all … Read full answer
Source: https://hireabo.com/job/12_0_6/Pipefitter